Makita 4322 사용 설명서 - 페이지 8

{카테고리_이름} Makita 4322에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Makita 4322 19 페이지.
Makita 4322에 대해서도 마찬가지입니다: 사용 설명서 (17 페이지)

Speed adjusting dial

For 4323 only

The tool speed can be infinitely adjusted between 500 and 3,100 strokes per minute by

turning the adjusting dial. Higher speed is obtained when the dial is turned in the direction

of number 6; lower speed is obtained when it is turned in the direction of number 1. Refer

to the table below to select the proper speed for the workpiece to be cut. However, the

appropriate speed may differ with the type

of thickness of the workpiece. In general,

higher speeds will allow you to cut work-

Speed adjusting dial

~~~

Wood

Mild steel

Stainless steel

pieces faster but the service life of the

bade will be reduced.

WorkDiece

be cut

Number on adlustins dial

5 - 6

3 - 6

3 - 4

Aluminum

3 - 6

Plastics

1 - 4

CAUTION:

The speed adjusting dial can be turned only as far as 6 and back to

1. Do

not force

past 6

or 1, or the speed adjusting function may not longer work.

Operation

CAUTION:

Always hold the tool base flush with the workpiece. Failure to do so may cause blade

breakage, resulting in a serious injury.

Turn the tool on and wait until the blade

attains full speed. Then rest the tool base

flat on the workpiece and gently move the

tool forward along the previously marked

cutting line. When cutting curves, advance

the tool very slowly.