CORNING SCF-1728 매뉴얼 - 페이지 6

{카테고리_이름} CORNING SCF-1728에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. CORNING SCF-1728 14 페이지. Heat shrink open ribbon system (hs-ors) canister splice closure

페이지 인쇄

Step 6: If more than one cable is being installed in the oval port, position the 3-finger clip between the two

cables at the end of the heat-shrink tube (Figure 11).

Step 7:

Hold the cable while heating to prevent any movement.

Step 8: Beginning at the port, gradually move a heat gun down the tube. Allow this portion of the tube to

cool before shrinking the rest of the tube onto the cable.

Attach Frame to End Cap

Step 1:

Remove splice plane and slack storage covers

TPA-6367

Step 2:

Secure the end cap on the work surface (table) with the express cable to the top.

Step 3:

Lay all the ribbon fiber from the express ports in a bundle in the middle storage area (Figure 13).

Step 4: Hold the express fibers in one hand and the ORS frame in the other hand.

Step 5:

Carefully reposition the ORS frame and secure it to the end cap.

IMPORTANT:

Make sure the end cap is oriented so that the express cables transition smoothly into the middle

storage area of the frame with no sharp bends in the cable.

3-finger Clip

Section

Figure 12.

Standard Recommended Procedure 206-455-AEN | Issue 1 | November 2018 | Page 6 of 14

TPA-3746

Figure 11

Figure 12