Makita 4326 사용 설명서 - 페이지 9
{카테고리_이름} Makita 4326에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Makita 4326 13 페이지. Jig saw
Makita 4326에 대해서도 마찬가지입니다: 사양 (2 페이지), 기술 정보 (7 페이지), 사용 설명서 (13 페이지), 사용 설명서 (13 페이지), 사용 설명서 (13 페이지)
페이지 인쇄
2.
Circular cuts
Steel base type
1
2
3
4
002777
Aluminum base type
4
005455
Steel base type
1
008098
Aluminum base type
1
008099
When cutting circles or arcs of 170 mm or less in
radius, install the rip fence as follows.
Insert the rip fence into the rectangular hole on the
side of the base with the fence guide facing up.
Insert the circular guide pin through either of the
two holes on the fence guide. Screw the threaded
knob onto the pin to secure the pin.
Now slide the rip fence to the desired cutting radius,
and tighten the bolt to secure it in place. Then
move the base all the way forward.
1. Treaded knob
2. Guide facing
3. Rip fence
(Guide rule)
4. Pin
1. Threaded knob
2. Pin
3. Rip fence
(Guide rule)
4. Fence guide
1
2
3
1. Rip fence
(Guide rule)
1. Rip fence
(Guide rule)
NOTE:
Always use blades No. B-17, B-18, B-26 or B-27
•
when cutting circles or arcs.
Anti-splintering device for steel base
(optional accessory)
1
008100
For splinter-free cuts, the anti-splintering device can be
used. To install the anti-splintering device, move the
base all the way forward and insert it between the two
protrusions of the base.
NOTE:
The anti-splintering device cannot be used when
•
making bevel cuts.
Anti-splintering device for aluminum base
(Optional accessory)
1
008101
For splinter-free cuts, the anti-splintering device can be
used. To install the anti-splintering device, move the tool
base all the way forward and fit it from the back of tool
base. When you use the cover plate, install the
anti-splintering device onto the cover plate.
CAUTION:
The anti-splintering device cannot be used when
•
making bevel cuts.
9
1. Anti-splintering
device
2. Protrusions
2
1. Anti-splintering
device
2. Aluminum base
2