Garage Tek GT100010A 설치 매뉴얼 - 페이지 7

{카테고리_이름} Garage Tek GT100010A에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Garage Tek GT100010A 16 페이지. Garage overhead storage racks

STEP 1: 4FT X 6FT RACK-FOR CEILING BRACKET INSTALLATION

(SOLID CONCRETE CEILING)

WE PROVIDED WOOD SCREWS AND SOLID CONCRETE CEILING ANCHORS FOR THIS INSTALLATION.

PLEASE DETERMINE THE TYPE OF CEILING YOU HAVE BEFORE STARTING.

SOLID CONCRETE CEILING:

A: USE THE DRILL TEMPLATE TO MARK THE MOUNTING HOLES FOR INSTALLATION.

A1: START FROM THE LEFT, PLACE THE DRILL TEMPLATE AND MARK THE (2) HOLES.

A2: FROM THE (1) END MEASURE 48", PLACE THE DRILL TEMPLATE AND MARK THE NEXT SET OF (2) HOLES.

B: PILOT HOLES CONCRETE CEILING: USE A 15/32" (12 mm) DIA. MASONARY DRILL BIT AND DRILL A 2 3/8" (60mm)

DEEP HOLE FOR EACH ANCHOR.

C: INSERT (1) ANCHOR INTO EACH HOLE. USE A RUBBER MALLET TO TAP THE ANCHOR INTO THE CEILING.

D: FASTEN THE CEILING BRACKETS TO THE ANCHORS. USE A DRILL AND THE SUPPLIED NUT DRIVER.

SEE ANCHOR INSTRUCTIONS BELOW, FIG D1-D4.

48.000IN

[1219.20mm]

REUSE THE DRILL TEMPLATE TO MARK MOUNTING HOLES ON THE CEILING

72.000in

1828.80mm

KEEP EACH SET OF CEILING BRACKETS IN A STAIGHT LINE

MARKED MOUNTING

HOLE WITH PENCIL

CONCRETE CEILING

DRILL MARKED MOUNTING HOLES

(2) MOUNTING HOLES REQUIRED

PER CEILING BRACKET.

USE A MASONARY DRILL BIT

11/64"

[

4.5mm]

MOUNTING HOLE DIMENSIONS

ANCHOR

2 3/8"

[60mm]

DRILLED

HOLE

ANCHOR

FIG. D1

FIG. D2

CEILING

BRACKET

FIG. D3

SUPPLIED

NUT DRIVER

DRILL

FIG. D4

PAGE 7