Makita 4329 사용 설명서 - 페이지 7
{카테고리_이름} Makita 4329에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Makita 4329 13 페이지. Jig saw
Makita 4329에 대해서도 마찬가지입니다: 사용 설명서 (13 페이지), 사양 (2 페이지), 기술 정보 (7 페이지), 사용 설명서 (13 페이지), 사용 설명서 (13 페이지)
페이지 인쇄
Bevel cutting
008088
CAUTION:
Always be sure that the tool is switched off and
•
unplugged before tilting the base.
Raise the dust cover all the way before making
•
bevel cuts.
With the base tilted, you can make bevel cuts at any
angle between 0° and 45° (left or right).
Loosen the bolt on the back of the base with the hex
wrench. Move the base so that the bolt is positioned in
the center of the cross-shaped slot in the base.
008089
Tilt the base until the desired bevel angle is obtained.
The edge of the motor housing indicates the bevel angle
by graduations. Then tighten the bolt to secure the base.
008090
1. Hex wrench
1
2. Bolt
2
3. Base
3
1. Edge
1
2. Graduation
2
Front flush cuts
008091
Loosen the bolt on the back of the base with the hex
wrench and slide the base all the way back. Then tighten
the bolt to secure the base.
Cutouts
Cutouts can be made with either of two methods A or B.
A) Boring a starting hole
008092
For internal cutouts without a lead-in cut from an
edge, pre-drill a starting hole 12 mm or more in
diameter. Insert the blade into this hole to start your
cut.
B) Plunge cutting
008093
You need not bore a starting hole or make a lead-in
cut if you carefully do as follows.
(1)
Tilt the tool up on the front edge of the base
with the blade point positioned just above the
workpiece surface.
(2)
Apply pressure to the tool so that the front
edge of the base will not move when you
switch on the tool and gently lower the back
end of the tool slowly.
7
1. Hex wrench
1
2. Bolt
2
3. Base
3
1. Starting hole
1