Garage1217 project ember 사용자 설명서 - 페이지 4

{카테고리_이름} Garage1217 project ember에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Garage1217 project ember 15 페이지.

Project

Ember

Bottom Chassis Prep / Final Chassis Assembly:

ASSEMBLE EACH OF THE 4 RUBBER FEET AS

SHOWN, ATTACHING EACH FOOT TO THE GRAY

SMOKED ACRYLIC BOTTOM CHASSIS

THREADED SPACER

GRAY ACRYLIC BOTTOM

RUBBER FOOT

NYLON WASHER

4-40 BUTTON CAP SCREW

- ONCE THE PCB HAS BEEN ASSEMBLED,

SET IT ONTO THE FOUR THREADS

STICKING OUT OF THE BOTTOM GRAY

ACRYLIC CHASSIS THAT YOU

PREVIOUSLY ASSEMBLED.

- THREAD ON EACH OF THE FOUR HEX

STANDOFFS ONTO THE THREADS THAT

ARE NOW PROTRUDING THROUGH THE

PCB, SECURING THE PCB TO THE GRAY

ACRYLIC CHASSIS BOTTOM. PROCEED

TO POWER ON THE UNIT (AS DESCRIBED

ON PAGE 2, WEARING EYE PROTECTION

AND AT A SAFE DISTANCE IN CASE OF A

MISTAKE IN ASSEMBLY)

- ONCE THE AMPLIFIERS FUNCTIONALITY

HAS BEEN TESTED AND THE UNIT HAS

HAD A CHANCE TO FULLY WARM UP FOR

30 MINUTES, SET THE BIAS AS

DESCRIBED LATER IN THIS MANUAL

BEFORE PLACING THE TOP CLEAR

ACRYLIC COVER IN PLACE

THUMB SCREW

CLEAR ACRYLIC TOP

STANDOFF

PCB

THREADED SPACER

GRAY ACRYLIC BOTTOM