Bernina HLT002 조립 지침 - 페이지 2
{카테고리_이름} Bernina HLT002에 대한 조립 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Bernina HLT002 5 페이지. Lift table extension kit
페이지 인쇄1. INSTALL TWIST CAM PINS
From back side of table locate!
6- 5mm holes on table bottom!
panel. Install 6- Twist Cam Pins!
using #2 Phillips Screwdriver as !
shown in Figure #1
2. INSTALL SHELF SIDES
Slide Shelf side onto Twist Cam Pins!
and with #2 Phillips Screwdriver turn!
twist cam clockwise until tight. !
Note: Make sure Twist Cams on !
Shelf Side are facing center of table!
as shown in Figure #2. If Shelf !
Side will not slide onto Twist!
cam pin refer to Figure #2-B!
below.
NOTE: MAKE SURE ARROW POINT ON!
CAM LOCK IS POINTING UP TO ALLOW!
FOR PROPER ALIGNMENT ON TWIST CAM PINS
LIFT TABLE EXTENSION KIT!
ASSEMBLY INSTRUCTIONS
TABLE BOTTOM!
PANEL
TWIST CAM
FIGURE #2-B
VIEW OF BACK OF TABLE
TWIST CAM PIN
VIEW OF BACK OF TABLE
PAGE 2
7/3/2019
FIGURE #1
FIGURE #2