GarageAce S3 소유자 매뉴얼 - 페이지 15
{카테고리_이름} GarageAce S3에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. GarageAce S3 16 페이지.
페이지 인쇄9.
Trouble shooting
Trouble
The motor doesn't work and
has no display on LED
The motor doesn't work and
the LED displays 1.
The door stops before it is fully
up on opening cycle; LED
displays 2. or 3.
Door auto-reverses before
reaching the ground on
closing; LED displays 3.
The door won't run in the
closing door direction, LED
display 4.
Motor stops after a moment
of running, LED display 7.
Motor cannot run, LED display
8
Push button can operate
normally, but remote control
won't
The remote working distance
is less, the brightness of
indicator lamp is lower
Remote operates normally,
but the push button work
respond
The product appearance and functions will be changed by development without further
notice. This manual is for reference only, the actual item is the standard.
Reason
●Opener is not powered on
●Fuse on main control board is
damaged
●Travel adjustment error
●The closing resistance is greater
than that system set load which
activates the barrier protection
system
●The closing resistance is greater
than that system set load
activates the barrier protection
system
● The photo beam is shielded;
● System started to use photo
beam system, but it hasn't been
connected.
● speed sensor wire is loosed
● speed sensor is broken
● DC motor wire is loosed
● DC motor is broken
● control board is broken
● The transmitter has not learned
● It has no battery in the
transmitter
●The battery power is not enough
● Push button loose or broken
circuit
11
Solution
●Switch on the power,
inspect " POWER" socket
●Change fuse to the same
type fuse.
●Re-adjust limit position
●Inspect and adjust the door
balance system
●Inspect and adjust the door
balance system
●increase door closing load
● Remove the barrier in the
beam road.
● Prohibit using photo beam
or connect the photo beam
● reconnect the wires
● change speed sensor
● reconnect the wires
● change DC motor
● change control board
● Learn transmitter according
to the manual
● Change the battery of
transmitter
● Change the battery
● Inspect push button wiring