GarageAce S3 소유자 매뉴얼 - 페이지 5
{카테고리_이름} GarageAce S3에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. GarageAce S3 16 페이지.
페이지 인쇄1.
Required tool list
No.
Name
1
Electric drill
2
Ladder
3
Mobile wrench or socket wrench
4
Measuring tape
5
Screw driver - Flat
6
Screw driver - Flat
7
Screw driver - Philips
8
Pincer
9
Allen key
2.
Important safety instructions
WARNING – INCORRECT INSTALLATION CAN LEAD TO SEVER INJURY. PLEASE FOLLOW ALL
INSTALLATION INSTRUCTIONS IN THIS MANUAL AND ALWAYS DO THE FOLLOWING:
1) Keep garage doors properly balanced. Have a professional service person make repairs
to cables, spring assemblies and other hardware.
2) Watch a moving door until it completely stops moving. Do not cross the path of a door in
motion. Do not let children play near a garage door when it is opening or closing.
3) Never put fingers between the sections of a garage door, and teach children to keep
their hands and fingers clear of section joints, hinges, tracks, springs and other door parts.
4) Do not let children play with transmitters or remote controls, and place these items out of
reach of children.
5) Test the automatic reversal monthly. The garage door MUST reverse on contact with a
40mm high object (or a 50mm by 100mm board laid flat) on the floor. If the garage door
does not reverse, adjust either the force or the limit of travel, and re-test the automatic
reversal. Be careful when making adjustments because mal-adjustments can cause
serious injury or death.
6) Disconnect the electrical power to the motor before making any repairs or removing the
housing cover.
7) If possible, use the emergency release only when the door is closed. Be careful when using
the release with the door open because weak or broken springs may allow the door to fall
rapidly, which can cause serious injury or death.
8) Do not use the emergency release rope to open or close the door!
9) All the Entrapment Warning Labels should be pasted in a prominent location.
10) Check the motor is functioning correctly on a monthly basis!
11) Please take good care of this manual after installation so as to have safety inspection and
maintenance program regularly according to the manual.
Specification
5m
2.5×100mm
6×200mm
6×200mm
10#、12#
1
Quantity
1
1
1 set
1
1
1
2
2
1