GarageAce S6 사용자 설명서 - 페이지 14

{카테고리_이름} GarageAce S6에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. GarageAce S6 20 페이지. Sectional/tilt garage door opener

is now inactive. Press the "SET" button

to confirm the setting and the opener will

return to standby mode.

Note: Set the photo-beam function to

"0" if you aren't using the photo-beam

sensors.

Auto-Close Setting

This option is only available if the door is

fully open and a photo beam is installed

and operational. The default setting is "0".

SET

Press and hold the SET" button for 3

CODE

DOWN

seconds until the LED flashes "1". Press

the "UP" or "DOWN" button until the LED

flashes "4", then press the "SET" button.

The unit is now in Auto-Close setting mode.

The LED displays the current setting.

Pressing the "UP" button once will increase

the auto-close time by 1 minute. The

maximum time is 9 minutes.

Pressing the "DOWN" button once will

decrease the auto-close time by 1 minute.

The auto-close function will be turned

off when the LED displays "0". Press the

"SET" button to confirm the setting and the

opener will return to standby mode.

The door can be opened manually if

required (i.e. in the case of a power outage).

Simply pull down the cord attached to the

shuttle mechanism to disengage the shuttle

(fig 12) and move door by hand.

To re-engage the door, simply run opener in

automatic mode or move the door by

hand until the belt catch engages with the

Fig 12

shuttle.

S6 Instruction Manual