Makita 4350CT 사용 설명서 - 페이지 7

{카테고리_이름} Makita 4350CT에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Makita 4350CT 13 페이지. Jig saw
Makita 4350CT에 대해서도 마찬가지입니다: 사양 (2 페이지), 사용 설명서 (13 페이지), 기술 정보 (14 페이지), 사용 설명서 (13 페이지)

페이지 인쇄

008008

Return the tool opener to its original position.

After installing, always make sure that the blade is

securely held in place by trying to pull it out.

CAUTION:

Do not open the tool opener excessively, or it may

•

cause tool damage.

To remove the blade, open the tool opener to the

position shown in the figure. Pull the saw blade out

toward the base.

008009

NOTE:

Occasionally lubricate the roller.

•

Hex wrench storage

008010

When not in use, the hex wrench can be conveniently

stored.

OPERATION

CAUTION:

Hold the tool firmly with one hand on the main

•

handle when performing the tool. If necessary, the

front part of the tool may be supported by the

other hand.

1. Blade clamp

2. Jig saw blade

3. Protrusions

1. Jig saw blade

1. Base

2. Hex wrench

Always hold the base flush with the workpiece.

•

Failure to do so may cause blade breakage,

resulting in a serious injury.

008011

Turn the tool on and wait until the blade attains full

speed. Then rest the tool base flat on the workpiece and

gently move the tool forward along the previously

marked cutting line. When cutting curves, advance the

tool very slowly.

Bevel cutting

CAUTION:

Always be sure that the tool is switched off and

•

unplugged before tilting the base.

With the base tilted, you can make bevel cuts at any

angle between 0° and 45° (left or right).

008012

Loosen the bolt on the back of the base with the hex

wrench. Move the base so that the bolt is positioned in

the center of the bevel slot in the base.

008013

Tilt the base until the desired bevel angle is obtained.

The V-notch of the gear housing indicates the bevel

angle by graduations. Then tighten the bolt firmly to

secure the base.

1. Cutting line

2. Base

1. Base

2. Bolt

3. Hex wrench