GarageInstruments FADED-50 사용자 설명서 - 페이지 13

{카테고리_이름} GarageInstruments FADED-50에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. GarageInstruments FADED-50 15 페이지.

E. Effect loop connection

FADED-50 effect loop consists of back panel connectors SEND /

RETURN (n.23 and n.25), controls FX Level and FX Mix (n.24

and n.26). Function of the effect loop is to put the external guitar

effect/processor in the way of amplifier audio chain (for instance

delay, chorus, EQ an so on).

Connect the external guitar effect according to fig.3

through 6.3mm MONO Jack/Jack cables. Fade out FX Level control

and channel volume control (CLEAN and DRIVE). Trigger the LOOP

switch n.3 to the upper position so the LOOP control light lights up.

Fig. 3 – Connection of external guitar effect

After the connection try to add some volume and FX level.

You should be able to hear the output from the speaker now. DRY

/WET (no-effect and after-effect signal) ratio is now controlled by

turning the FX MIX control (n.26).

Switching the control n.3 or switching footswitch button, the effect

loop is activated/deactivated. To change topology of the loop from

parallel to series, set the FX Mix control to 100% WET.