Makita 5090D 사용 설명서 - 페이지 10

{카테고리_이름} Makita 5090D에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Makita 5090D 17 페이지. 85mm with fast charger
Makita 5090D에 대해서도 마찬가지입니다: 부품 목록 (1 페이지), 부품 분석 (2 페이지)

페이지 인쇄

BATTERY

continued

Charging the Battery

continued

NOTE:

If the charging light does not come on:

i. Press the Reset button (yellow)

ii. Then press the Start button (red).

If the charging light goes out within 10 seconds even after pressing the

Reset button and Start button a couple of times, the battery cartridge is

dead. (CAUTION: Wait for more than 5 seconds after the charging light

goes out before pressing the Reset button again).

Replace the battery cartridge with a new one.

CAUTION

Do not

keep the button pressed in with tape, etc. or the circuit will not function

properly. Also, a malfunction of the charger may result possibly causing

overheating, etc.

If you try to charge a cartridge from a just-operated tool, sometimes the

charging light will not come on. If this occurs, let the cartridge cool off for a

while, then re-insert it and try to charge it once more.

If you wish to charge two battery cartridges, allow 15 minutes between

chargings on the fast charger.

Recycling the Battery

The

to recycle it. The law prohibits any other

way to dispose of a Makita battery is

method of disposal.

Ni-Cd

To recycle the battery:

1. Remove the battery from the tool.

2. a). Take the battery to your nearest Makita Factory Service Center

b). Take the battery to your nearest Makita Authorized Service Center or

Distributor that has been designated as a Makita battery recycling location.

Call your nearest Makita Service Center or Distributor to determine the

location that provides Makita battery recycling. See your local Yellow Pages

under "Tools

Electric.