Makita 5092D 사용 설명서 - 페이지 4
{카테고리_이름} Makita 5092D에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Makita 5092D 19 페이지. Cordless circular saw
Makita 5092D에 대해서도 마찬가지입니다: 부품 목록 (2 페이지)
페이지 인쇄
IMPORTANT SAFETY INSTRUCTIONS
FOR CHARGER &
BATTERY CARTRIDGE
I.
SAVE THESE INSTRUCTIONS
-
This manual
Length of Cord (Feet)
AWG Size of Cord
contains important safety and operating instructions for battery charger.
2.
Before using battery charger, read all instructions and cautionary markings
on
(1)
battery charger,
( 2 )
battery, and
(3)
product using battery.
3.
CAUTION - To reduce risk of injury, charge only MAKITA Battery Cartridge
9000, 9100, 1200
&
1210.
Other types of batteries may burst causing
personal injury and damage.
4. Do not expose charger t o rain or snow.
5.
Use of an attachment not recommended or sold by the battery charger
manufacturer may result in a risk of fire, electric shock, or injury t o persons.
6.
To reduce risk of damage to electric plug and cord, pull
by
plug rather than
cord when disconnecting charger.
7.
Make sure cord is located so that it will not be stepped on, tripped over, or
otherwise subjected t o damage or stress.
8.
An extension cord should not be used unless absolutely necessary. Use of
improper extension cord could result in a risk of fire and electric shock.
If
extension cord must be used, make sure:
a. That pins on plug of extension cord are the same number, size, and shape
b. That extension cord is properly wired and in good electrical condition; and
c. That wire size is at least as large as the one specified in the table below.
TABLE
1
RECOMMENDED MINIMUM AWG SIZE
FOR
EXTENSION CORDS FOR BATTERY CHARGERS
as those of plug on charger;
25
50
100
150
18
18
18
16
9.
Do not operate charger w i t h damaged cord or plug - replace them im-
mediately.
IO.
Do not operate charger if it has received a sharp blow, been dropped, or other-
wise damaged in any way; take it t o a qualified serviceman.
1 1 .
Do not disassemble charger or battery cartridge; take it t o a qualified
serviceman when service or repair is required. Incorrect reassembly may
result in a risk of electric shock or fire.
12.
To reduce risk of electric shock, unplug charger f r o m outlet before attempt-
ing any maintenance or cleaning. Turning off controls will not reduce this risk.
4