Makita 5603R 사용 설명서 - 페이지 7
{카테고리_이름} Makita 5603R에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Makita 5603R 13 페이지. 165/190/235 mm
Makita 5603R에 대해서도 마찬가지입니다: 사용 설명서 (13 페이지), 매뉴얼 (15 페이지), 사용 설명서 (13 페이지), 사용 설명서 (13 페이지), 사용 설명서 (12 페이지), 사용 설명서 (16 페이지)
페이지 인쇄
17. Never attempt to saw with the circular saw
held upside down in a vise. This is extremely
dangerous and can lead to serious accidents.
(Fig. G)
OPERATING INSTRUCTIONS
Removing or installing saw blade
The following blade can be used with this tool.
Model
Max. dia.
5603R
165 mm
5705R
190 mm
5903R
235 mm
The thickness of the riving knife is 1.8 mm for Models
5603R and 5705R or 2.0 mm for Model for 5903R.
CAUTION:
• Do not use saw blades which do not comply with the
characteristics specified in these instructions.
• Do not use saw blades the disc of which is thicker or
the set of which is smaller than the thickness of the
riving knife.
To remove the saw blade, depress the shaft lock fully
to prevent shaft rotation, then use the hex wrench to
loosen the hex socket head bolt. (Fig. 1)
Now remove the outer flange, raise the safety cover
as much as possible, and remove the saw blade.
(Fig. 2)
18. Before setting the tool down after completing
a cut, be sure that the lower (telescoping)
guard has closed and the blade has come to a
Fig. F
complete stop.
19. Using manufacturer data
• Ensure that the diameter, thickness and other
characteristics of the saw blade are suitable for
the tool.
• Ensure that the saw blade is suitable for the
spindle speed of the tool.
20. Do not use any abrasive wheel.
SAVE THESE INSTRUCTIONS.
Min. dia.
Blade thickness
150 mm
less than 1.7 mm
170 mm
less than 1.7 mm
210 mm
less than 1.9 mm
Install the saw blade using the reverse of the removal
procedure. Install the inner flange, saw blade, outer
flange and hex socket head bolt, in that order. Be sure
to secure the hex socket head bolt tightly with the
shaft lock fully depressed. (Fig. 1 & 3)
CAUTION:
• Make sure that the blade teeth point forward in the
same direction as the tool rotation (the arrow on the
blade should point in the same direction as the
arrow on the tool).
• Never depress the shaft lock while the saw is
running.
• Use only the Makita socket wrench to remove or
install the blade.
Fig. G
Kerf
more than 1.9 mm
more than 1.9 mm
more than 2.1 mm
7