HIKVISION DS-7216HUHI-K2(S) 빠른 시작 매뉴얼 - 페이지 13

{카테고리_이름} HIKVISION DS-7216HUHI-K2(S)에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. HIKVISION DS-7216HUHI-K2(S) 17 페이지.

powered on and then powered off, and there is no video and "Insufficient Power for PoC" is overlaid on

the live view image.

 If the power consumption of the DVR is higher than that of the AT camera, when AF or AT camera is

connected, it is powered on normally.

Step 4 Check the connected AF or AT camera number and the connectable camera number.

 Only Hikvision PoC camera is supported.

 The maximum connectable AT/AF camera number varies with different models.

Please turn off the PoC function if the camera does not support PoC, or the camera is not produced by

Hikvision. Otherwise, it may result in permanent damage to the camera or DVR.

3.9 Network Settings

3.9.1 Configure General Settings

Purpose

Network settings must be properly configured before you operate DVR over network.

Step 1 Go to System > Network > TCP/IP.

Step 2 In the General Settings interface, you can

configure the following settings: NIC Type,

IPv4 Address, IPv4 Gateway, MTU and DNS

Server.

Step 3 Save the settings.

3.9.2 Configure Hik-Connect

Purpose

Hik-Connect provides mobile phone application and platform service to access and manage your connected

devices, which enables you to get a convenient remote access to the surveillance system.

Step 1 Go to System > Network > Advanced > Platform Access.

Step 2 Check Enable to activate the function. Then the service terms will pop up.

1) Enter the verification code in Verification Code.

2) Scan the QR code to read the service terms and privacy statement.

Digital Video Recorder Quick Start Guide

Figure 3-7 Network Settings