Makita 5620D 사용 설명서 - 페이지 5

{카테고리_이름} Makita 5620D에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Makita 5620D 12 페이지.

15. Avoid Cutting Nails.

Inspect for and remove all nails from lumber

before cutting.

16. Operate with proper hand support and proper

workpiece support.

WARNING:

It is important to support the workpiece properly

and to hold the saw firmly to prevent loss of

control which could cause personal injury. Fig. 4

illustrates typical hand support of the saw.

A typical illustration of proper hand support and work-

piece support.

17. Place the wider portion of the saw base on that

part of the workpiece which is solidly sup-

ported, not on the section that will fall off when

the cut is made.

As example, Fig. 5 illustrates the RIGHT way to

cut off the end of a board, and Fig. 6 the WRONG

way. If the workpiece is short or small, clamp it

down. DON'T TRY TO HOLD SHORT PIECES BY

HAND! (Fig. 6)

SAVE THESE INSTRUCTION

Fig. 4

Fig. 5

18. Never attempt to saw with the circular saw held

upside down in a vise. This is extremely danger-

ous and can lead to serious accidents. (Fig. 7)

19. Before setting the tool down after completing a

cut, be sure that the lower (telescoping) guard

has closed and the blade has come to a com-

plete stop.

20. Using manufacturer data

•

Ensure that the diameter, thickness and

other characteristics of the saw blade are

suitable for the tool.

•

Ensure that the saw blade is suitable for the

spindle speed of the tool.

21. Do not use any abrasive wheel.

Fig. 6

Fig. 7