JAMEC PEM 58.302 사용 설명서 - 페이지 4

{카테고리_이름} JAMEC PEM 58.302에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. JAMEC PEM 58.302 8 페이지. Air and water hose reel

페이지 인쇄

IMPORTANT:

If the hose becomes tangled and will not retract - slowly pull out the hose past the tangled

section and then allow the hose to slowly retract while guiding the hose back into the hose reel.

Always ensure the hose is clean and not twisted.

ADJUSTING THE STOP-BALL

The location of the hose stopper can be

adjusted to allow more hose or less hose to

be exposed when fully rewound.

1. Pull out the desired length of hose, ensuring

the hose reel is in the lock position.

2. Open the latch on the hose stopper and

move it to the desired position on the hose.

3. Re-latch the hose stopper at desired

position

CAUTION:

Always make sure the hose reel is in the

locked position before removing the hose

stopper and make sure the hose stopper is

securely fastened before unlocking the reel.

ADJUSTING THE

TENSION SPRING

Over time it is natural for the spring to lose

some tension. The tension can easily be

adjusted and tightened to provide years of

service.

CAUTION:

Only adjust the spring when the hose is fully

rewound. Do Not Over-tighten

1. Using a flat head screw driver, remove the

side cover marked "Coil Spring Adjustment"

by prying it open where indicated.

2. Fold out the crank handle.

3. Turn the crank clockwise to increase

the tension, counter clock-wise to reduce

the tension.

4. Turn the crank handle five times in the

desired direction. Check the spring tension

by pulling a short length of the hose and

letting it rewind.

5. Repeat this process until there is just

enough tension to fully rewind the hose

6. The hose tension should only to tensioned

to the point where the hose stopper "just"

makes it back to the hose reel. If the hose

is returning to hard and fast to the hose reel

then the tension is too much and needs to

be adjusted accordingly. (Over tensioning

will not be covered by warranty)