Bernina Record 830 소프트웨어 업데이트 - 페이지 5

{카테고리_이름} Bernina Record 830에 대한 소프트웨어 업데이트을 온라인으로 검색하거나 PDF를 다운로드하세요. Bernina Record 830 14 페이지. Workbook 3 creative options
Bernina Record 830에 대해서도 마찬가지입니다: 브로셔 (2 페이지), 지침 및 팁 (4 페이지), 통합 문서 (16 페이지)

페이지 인쇄
Bernina Record 830 소프트웨어 업데이트

2.3 The use of straight stitch feet with thread cutting

The opening of the straight stitch foot is 0.4mm on both sides. The "tie on" stitch after cutting is
0.4mm to the left side. After thread cutting, the first stitch failed resulting in the animation "need-
le will penetrate presser foot" due to the narrow tolerance in the foot opening. This has been
resolved.

2.4 Disable automatic thread cutting when opening the bobbin door

Previously the thread was cut automatically before the hook turned to the front.
To accommodate the need to change the bobbin without cutting the upper thread, the cutter is
disabled and the "lower thread empty" message appears.

2.5 Thread cutting without fabric movement

Thread cutting with the needle stop down, will NOT result in fabric movement.

2.6 "Manual" winding of the lower bobbin thread

The filling process stops at a detection of 100% fill level. As a result of mechanical tolerances, it
is possible that the bobbin does not fill to the maximum capacity.
5/14, 04.11.2009