Makita 6823 사용 설명서 - 페이지 8
{카테고리_이름} Makita 6823에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Makita 6823 17 페이지. Drywall screwdriver
Makita 6823에 대해서도 마찬가지입니다: 부품 분석 (3 페이지), 사용 설명서 (8 페이지), 사용 설명서 (8 페이지), 사용 설명서 (7 페이지), 사용 설명서 (10 페이지), 기술 정보 (10 페이지), 사용 설명서 (12 페이지)
페이지 인쇄
ASSEMBLY
1
1. Locator
2. Locking sleeve
2
3
1. Locator
2. Bit
3. Magnetic bit holder
OPERATION
8
CAUTION:
•
Always be sure that the tool is switched off and
unplugged before carrying out any work on the tool.
Installing or removing the bit
To remove the bit, first pull the locator out of the locking
002653
sleeve. Then grasp the bit with a pair of pliers and pull the bit
out of the magnetic bit holder. Sometimes, it helps to wiggle
the bit with the pliers as you pull.
2
To install the bit, push it firmly into the magnetic bit holder.
002661
Then install the locator by pushing it firmly back onto the
1
locking sleeve.
Fit the screw on the point of the bit and place the point of the
002673
screw on the surface of the workpiece to be fastened. Apply
pressure to the tool and start it. Withdraw the tool as soon as
the clutch cuts in. Then release the switch trigger.
CAUTION:
•
When fitting the screw onto the point of the bit, be careful
not to push in on the screw. If the screw is pushed in, the
clutch will engage and the screw will rotate suddenly.
This could damage a workpiece or cause an injury.
•
Make sure that the bit is inserted straight in the screw
head, or the screw and/or bit may be damaged.