Makita 6823 사용 설명서 - 페이지 4
{카테고리_이름} Makita 6823에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Makita 6823 8 페이지. Drywall screwdriver
Makita 6823에 대해서도 마찬가지입니다: 사용 설명서 (17 페이지), 부품 분석 (3 페이지), 사용 설명서 (8 페이지), 사용 설명서 (7 페이지), 사용 설명서 (10 페이지), 기술 정보 (10 페이지), 사용 설명서 (12 페이지)
페이지 인쇄
WARNING:
MISUSE or failure to follow the safety rules stated in
this instruction manual may cause serious personal
injury.
FUNCTIONAL DESCRIPTION
CAUTION:
Always be sure that the tool is switched off and
•
unplugged before adjusting or checking function on
the tool.
Depth adjustment
1
A
B
002612
The depth can be adjusted by turning the locking sleeve.
Turn it in "A" direction for less depth and in "B" direction
for more depth. One full turn of the locking sleeve equals
1.5 mm change in depth.
Adjust the locking sleeve so that the distance between
the tip of the locator and the screw head is
approximately 1 mm as shown in the figures. Drive a trial
screw into your material or a piece of duplicate material.
If the depth is still not suitable for the screw, continue
adjusting until you obtain the proper depth setting.
1mm
004149
1mm
004154
1. Locking sleeve
1. Locator
1
1. Locator
1
Switch action
1
002628
CAUTION:
Before plugging in the tool, always check to see
•
that the switch trigger actuates properly and
returns to the "OFF" position when released.
To start the tool, simply pull the switch trigger. Tool
speed is increased by increasing pressure on the switch
trigger. Release the switch trigger to stop.
For continuous operation, pull the switch trigger and
then push in the lock button.
To stop the tool from the locked position, pull the switch
trigger fully, then release it.
NOTE:
Even with the switch on and motor running, the bit
•
will not rotate until you fit the point of the bit in the
screw head and apply forward pressure to engage
the clutch.
Reversing switch action
1
A
B
002635
CAUTION:
Always check the direction of rotation before
•
operation.
Use the reversing switch only after the tool comes
•
to a complete stop. Changing the direction of
rotation before the tool stops may damage the tool.
This tool has a reversing switch to change the direction
of rotation. Move the reversing switch lever to
the
position (A side) for clockwise rotation or
the
position (B side) for counterclockwise rotation.
4
1. Switch trigger
2. Lock button
2
1. Reversing
switch lever