Avantgarde LBWC-44SB2 사용 설명서 - 페이지 20
{카테고리_이름} Avantgarde LBWC-44SB2에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Avantgarde LBWC-44SB2 20 페이지. Built-in wine cooler
페이지 인쇄
7.TROUBLESHOOTING GUIDE
You can solve many common appliance problems easily, saving you the cost of a possible Service Call.
Try the suggestions below to see if you can solve the problem before calling for service.
PROBLEM
Display flash and indicate "HH", flash speed
one time per second
Display flash and indicate "LL", flash speed
one time per second
Display flash and indicate "E0", flash speed
one time per second
Display flash and indicate "E1", flash speed
one time per second
Display flash and indicate "E2", flash speed
one time per second
Appliance does not operate.
Temperature inside the appliance is too
warm.
Temperature inside the appliance is too
cold.
Vibrations
Moisture forms on inside appliance walls.
Moisture forms on outside of appliance.
The door will not close properly.
TO CONTACT THE AUTHORIZED SERVICE CENTER:
A.G.I SERVICE
450.963.1303/1.888.651.2534
POSSIBLE CAUSE
The temperature sensor of zone>37°
The temperature sensor of zone<0°
Connection failure, wire or component is not
connect tightly
The temperature sensor is failure in corresponding
zone
The defrost sensor (coil senor) is failure in
corresponding zone
Not plugged in.
The circuit breaker has tripped or there is a blown
fuse.
Temperature control is set too warm.
control to a cooler setting and allow several hours
for the temperature to stabilize.
Door is kept open too long or is opened too
frequently. Warm air enters the appliance every
time the door is opened. Open the door less often.
The door is not closed completely.
The door gasket does not seal properly.
The appliance has recently been disconnected for
a period of time.
4 hours are required for the
appliance to cool down completely.
Temperature control is set too cold.
control to a warmer setting and allow several hours
for the temperature to stabilize.
Check to assure that the appliance is on a level
surface.
The appliance is touching the wall. Re-level the
appliance and move it from the wall.
If continued vibration occurs, turn off the appliance
and unplug the power plug.
Service Dept. for further assistance.
Door is slightly open.
Door is kept open too long, or is opened too
frequently. Open the door less often.
The door is not sealed properly.
Door is slightly open, causing cold air from inside
the appliance to meet warm moist air from outside.
The appliance is not on a level surface.
The gasket is dirty.
Turn the
Turn the
Contact Customer
20