Avantgarde SOLO 사용 설명서 - 페이지 11

{카테고리_이름} Avantgarde SOLO에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Avantgarde SOLO 19 페이지.

SOLO

OPERATION

POWER ON/OFF SWITCH

(See graphic 7)

The SOLO has a 3-position power switch

POSITION I (= permanent ON), POSITION

II (= remote ON) and middle POSITION 0 (=

permanent OFF).

a) In POSITION I (= ON) the SOLO will be

permanently ON. The SOLO has been

designed for permanent use. Due to sonic

advantages we recommend to leave it always

switched ON. Power consumption is approx.

15 Watts when not in use.

b) In POSITION II (= REMOTE) the operation

mode of the SOLO is remotely triggered.

Connect the respective remote trigger cable

(12 V= switching voltage) of your electronics

with the REMOTE socket

electronics (surround receiver, multi room

amplifier etc.) is turned ON/OFF, the SOLO

will automatically switch ON/OFF. For details

on wiring please refer to the manual of your

electronics as well.

c) In POSITION 0, the SOLO is turned to

permanent OFF. If you prefer to switch the

subwoofers OFF after listening you can

either use the power-switch on the back or

an external power-switch. Switching-noises

when turning the speaker OFF are normal

and present no danger to the SOLO drivers or

amplifier. If your HiFi equipment is not in use

over a longer period turn the system OFF.

Version 1.4 – May 25, 2007

(See graphic 7)

Missing or faulty earth of the mains system might

cause audible hum noise. In this case the SOLO

earthing contact can be deactivated by switching

the GND-switch

= factory setting). Just simply check which position

is best.

. As soon as your

to OFF position (position ON

www.avantgarde-acoustic.de

page 11