Avantgarde SOLO 사용 설명서 - 페이지 16
{카테고리_이름} Avantgarde SOLO에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Avantgarde SOLO 19 페이지.
페이지 인쇄
SOLO
SYSTEM SET UP
BURN–IN TIME
The speakers usually need at least 40 hrs. of
running-in. During this period sound quality will
almost improve "minute by minute". After this
time it may be necessary to check and correct the
system set-up (positioning and amplifier-settings).
Please leave the SOLOs continuously ON during
this run-in period. In total, changes will be
noticeable usually during the first 80-100 hrs.
Afterwards the speaker can be considered run-
in and is ready for experiments with fine-tuning
equipment.
CABLES
Due to the high efficiency of hornspeakers there is
a very low signal-level running through the speaker
cables when using a power amplifier or integrated
amplifier signal. In our experience speaker cables
which are shielded or are constructed to minimize
interaction of the signal with internal or external
magnetic fields are always a reasonable choice.
If the SOLO is connected via the RCA signal of a
preamplifier we recommend using a shielded high
quality cable. Always check the recommended
electrical flow direction of the cable before
connecting it!
GENERAL ADVISE
Personal experiments are always better than
theoretical studies! Please ask your dealer for
more advice and for home testing. The same is
recommended if you want to change the speakers
mains cable.
Version 1.4 – May 25, 2007
CLEANING OF HORNS
We recommend to regularly clean the white or
metallic-coated horns with a dry soft fabric (duster)
or a Rouge-brush.
To remove finger prints and dirty spots we
recommend the use of glass detergent.
To remove small scratches we recommend the
use of automotive waxes and polishing compounds
for cars. Please proceed carefully and strictly follow
the cleaning instructions of the manufacturer.
IMPORTANT
Do not touch the membranes while cleaning
the horns!
Avoid scratching the horns with dirty fabrics and
never use „aggressive" detergents or abrasives!
Never use automotive waxes and polishing
components on „silky sheen"-coated surfaces
(enclosure of SOLO)!
CLEANING OF NEXTEL COATED SURFACES
To clean the Nextel coated surfaces of the
enclosure only use a sponge or foam! Dust also
can be carefully removed with a vacuum cleaner
and a duster brush.
IMPORTANT
Never use normal soft fabrics (duster) to clean
the Nextel coated surfaces of the enclosure.
Soft fabrics will cause fluffs sticking to the rough
structure of the Nextel surface.
Only dry-clean the Nextel surfaces.
Never use wet detergents.
www.avantgarde-acoustic.de
page 16