Jameco Electronics 2168940 매뉴얼 - 페이지 3

{카테고리_이름} Jameco Electronics 2168940에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Jameco Electronics 2168940 13 페이지.

one. When you solder, don't hold the iron more than 2 seconds on the LED, otherwise it can be damaged. Apply minimal solder

between each LED. I would NOT recommend to cut any wires until you have a working structure.

Step 4 - Solder in Rows

Go row by row, in the same way as before. Make sure to apply minimal heat, and place the legs just close enough to each other, but

not too close.

Step 5 - Add Reinforcements

You must strengthen each layer to make them stable and durable. This is so the layer doesn't come apart when you pull it off the rig.

Cut a piece of wire longer than the length of your layer and strip off the insulation. Place the long, stripped wire into a vice and pull

hard to straighten it. You can do this with another set of pliers as well. You should feel the wire get longer and straighter as you pull.

Once it is straight enough, place it on the opposite end of the layer and solder it on the cathodes to stabilize the rear end. Do this

once more for the middle section, as now it is the weakest part of the layer. I used clips to hold the reinforcement bar in place while I

soldered. These bars should strengthen the rear and middle of the cube so it won't break.