HIKVISION DS-73HUHI-F4/N Series 빠른 시작 매뉴얼 - 페이지 7
{카테고리_이름} HIKVISION DS-73HUHI-F4/N Series에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. HIKVISION DS-73HUHI-F4/N Series 17 페이지.
페이지 인쇄
6
S E T U P N E T W O R K A C C E S S
A network connection is required to access the cameras remotely.
1.
Go to MENU > SYSTEM CONFIGURATION > NETWORK > GENERAL.
2.
Use pull-down Working Mode menu to select "Multi-address."
3.
Use the pull-down Select NIC menu to select the network interface card you want to configure as the
camera LAN ("LAN 1" or "LAN 2").
4.
Use the pull-down Default Route menu to select the NIC that is to connect to the cameras' LAN.
Uncheck the Enable DHCP checkbox.
5.
6.
Set the IPv4 network IP address, subnet mask, and default gateway to match the IP subnet of the
cameras.
7.
Use the pull-down Select NIC menu to select the network interface card you want to configure for the
external computer LAN.
8.
Set the IPv4 network IP address, subnet mask, and default gateway to match the IP subnet of the
external computer LAN.
9.
Change the "Preferred DNS Server" value to 8.8.8.8 (leave Alternate DNS Server blank).
7
S E T R E M O T E V I E W I N G P O R T S
After assigning the IP information, click the More Settings tab.
The More Settings tab contains the ports that need to be forwarded for remote access.
GENERAL TAB (Select)
WORKING MODE
Set to Multi-address
SELECT NIC (To configure)
DEFAULT ROUTE (Camera LAN)
ENABLE DHCP
Router assigns IP address
REFRESH (Press to update)
IP V4 ADDRESS
Default 192.0.0.64
PREFERRED DNS SERVER
Default is 8.8.8.8
ALTERNATE DNS SERVER
Leave blank