Makita 9910 사용 설명서 - 페이지 6

{카테고리_이름} Makita 9910에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Makita 9910 8 페이지. 76mm
Makita 9910에 대해서도 마찬가지입니다: 부품 분석 (3 페이지), 사용 설명서 (17 페이지), 부품 분석 (3 페이지), 사용 설명서 (13 페이지), 사용 설명서 (8 페이지), 기술 정보 (5 페이지), 사용 설명서 (17 페이지)

페이지 인쇄

Sanding operation (Fig. 6)

CAUTION:

When sanding drywalls, connect the tool Makita vacuum

cleaner.

Hold the tool firmly with both hands. Turn the tool on and

wait until it attains full speed. Then gently place the tool

on the workpiece surface. Keep the belt flush with the

workpiece at all times and move the tool back and forth.

Never force the tool. The weight of the tool applies ade-

quate pressure. Excessive pressure may cause stalling,

overheating of the motor, burning of the workpiece and

possible kickback.

Clamps (optional accessory) (Fig. 8)

This tool can be operated in the inverted position. To do so, secure the tool to a stable workbench with two clamps as

shown in Fig. 8.

Connecting to Makita vacuum cleaner or dust collector

Cleaner sanding operations can be performed by connecting the belt sander to Makita vacuum cleaner or dust collec-

tor.

When connecting to Makita vacuum cleaner (Model 406/431), an optional hose 28 mm in inner diameter is necessary.

See the figure below.

Makita vacuum cleaner

When connecting to Makita dust collector (Model 420), the optional hose is not necessary. You can connect the belt

sander directly to the hose of the dust collector.

MAINTENANCE

CAUTION:

Always be sure that the tool is switched off and

unplugged before carrying out any work on the tool.

Replacement of carbon brushes (Fig. 9, 10 & 11)

Replace carbon brushes when they are worn down to the

limit mark. First, remove the belt cover from the tool, then

replace the carbon brushes. Both identical carbon

brushes should be replaced at the same time.

To maintain product safety and reliability, repairs, mainte-

nance or adjustment should be carried out by a Makita

Authorized Service Center.

Hose of vacuum cleaner

Speed adjusting dial (Fig. 7)

For 9911 only

The belt speed can be infinitely adjusted between 75 m

and 270 m per minute by turning the speed adjusting dial

to a given number setting from 1 to 6. Higher speed is

obtained when the dial is turned in the direction of num-

ber 6; lower speed is obtained when it is turned in the

direction of number 1. Select the proper speed for the

workpiece to be sanded.

CAUTION:

The speed adjusting dial can be turned only as far as 6

and back to 1. Do not force it past 6 or 1, or the speed

adjusting function may no longer work.

Optional hose 28 mm in inner dia.