Makita AF601 사용 설명서 - 페이지 4

{카테고리_이름} Makita AF601에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Makita AF601 13 페이지. Narrow crown stapler
Makita AF601에 대해서도 마찬가지입니다: 사용 설명서 및 사용자 설명서 (13 페이지)

페이지 인쇄
Makita AF601 사용 설명서
17. Never attempt to drive fasteners from both the
inside and outside at the same time. Fasteners
may rip through and/or fly off, presenting a grave
danger.
Service
1.
Perform cleaning and maintenance right after
finishing the job. Keep the tool in tip-top condi-
tion. Lubricate moving parts to prevent rusting and
minimize friction-related wear. Wipe off all dust
from the parts.
2.
Ask Makita authorized service center for peri-
odical inspection of the tool.
3.
To maintain product SAFETY and RELIABILITY,
maintenance and repairs should be performed
by Makita Authorized Service Centers, always
using Makita replacement parts.
SAVE THESE INSTRUCTIONS.
WARNING:
DO NOT let comfort or familiarity
with product (gained from repeated use) replace
strict adherence to safety rules for the subject
product. MISUSE or failure to follow the safety
rules stated in this instruction manual may cause
serious personal injury.
PARTS DESCRIPTION
► 1 . Trigger 2. Nose adapter (contact element)
3. Hook 4. Magazine
1
4
2

INSTALLATION

Selecting compressor
100
80
60
2
40
20
1. Nailing frequency (times/min) 2. Compressor air
output per minute (L/min) 3. 0.83 MPa (8.3 bar) 4. 0.66
MPa (6.6 bar) 5. 0.49 MPa (4.9 bar)
The air compressor must comply with the requirements
of EN60335-2-34.
Select a compressor that has ample pressure and air
output to assure cost-efficient operation. The graph
shows the relation between nailing frequency, applica-
ble pressure and compressor air output.
Thus, for example, if nailing takes place at a rate of
approximately 60 times per minute at a compression
of 0.66 MPa (6.6 bar), a compressor with an air output
over 80 liters/minute is required.
Pressure regulators must be used to limit air pressure to
the rated pressure of the tool where air supply pressure
exceeds the tool's rated pressure. Failure to do so may
result in serious injury to tool operator or persons in the
vicinity.
Selecting air hose
CAUTION:
3
or a long or smaller diameter air hose in relation
to the nailing frequency may cause a decrease in
the driving capability of the tool.
4 ENGLISH
10
20
30
40
1
Low air output of the compressor,
3
4
5
50
60