Garaventa Lift X3 빠른 시작 매뉴얼 - 페이지 4
{카테고리_이름} Garaventa Lift X3에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Garaventa Lift X3 7 페이지. Incline wheelchair lifts
페이지 인쇄a.
Platform Size A: 31-1/2 inches (800 mm) wide by 48 inches (1220 mm)
long (only available on commercial units, ADA-compliant)
b.
Platform Size B: 31-1/2 inches (800 mm) wide by 41-3/8 inches (1050
mm) long.
c.
Platform Size C: 31-1/2 inches (800 mm) wide by 35-1/2 inches (900
mm) long.
d.
Platform Size D: 27-1/2 inches (700 mm) wide by 29-1/2 inches (750
mm) long.
6.Platform Operation:
a.
Manual fold: Platform is manually folded and unfolded at the landing
(residential applications only).
b.
Automatic Fold: Folded and unfolded electrically from the call station.
c.
Emergency Manual Fold: When left in the open position, platform may
be manually folded and retained in the closed position.
7.Under Platform Obstruction Sensing:
a.
Provide under-platform sensing device to stop platform from traveling in
the downward direction when encountering 4 lb/f (20 N) of pressure.
b.
Platform is permitted to travel in the opposite direction of the
obstruction to allow clearing.
8.Passenger Curved Safety Arms:
a.
Platform equipped with retractable passenger restraining arms.
b.
Arms stop moving when an obstruction causing 4 lb/f (20 N) of
pressure is encountered and immediately retract when signal is
removed.
c.
Arms folded and unfolded electrically from the call stations or platform
controls.
d.
Provide with means to manually unlock and open the restraining arms
for passenger emergency evacuation.
e.
Top of arms mounted 37-3/8 inches (948 mm) above platform deck.
When in guarding position arms are located above the perimeter of the
platform.
f.
Gaps between ends of the arms shall not exceed 4 inches (100 mm).
9.Boarding Ramps:
a.
Provide boarding sides of platform with retractable ramps positioned for
travel at a height of 6 inches (150 mm) measured vertically above
platform deck.
b.
Ramps lock in guarding positions during travel. When platform is at the
landing, only the retractable ramp servicing the landing shall be
operable.
c.
Ramps fold and unfold manually, simultaneous to the manual fold or
unfolding of the manual platform.
d.
Ramps folded and unfolded electrically.
e.
Retractable ramps, in the guarded position, shall withstand a force of
125 lb/f (550 N) applied on any 4 inches (100 mm) by 4 inches (100
mm) area. This force shall not cause the height of the ramp, at any
point in its length, to be less than 6 inches (150 mm) measured
vertically above the platform deck.
f.
Provide a means to manually unlock the ramps for emergency
evacuation when platform is located at landing.
g.
Provide with a bi-directional obstruction sensitive device on the travel
direction end of the platform to stop the lift when 4 lb/f (20 N) of
pressure is encountered from either inside or outside of the platform.
Platform is permitted to travel in the opposite direction of obstruction to
allow clearing.
10. Platform Kick Plate:
X3 Specification 23265-A-DS Section 14 42 13
Page 4