Makita BCS550 사용 설명서 - 페이지 7
{카테고리_이름} Makita BCS550에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Makita BCS550 12 페이지. Cordless metal cutter 136mm (5-3/8")
Makita BCS550에 대해서도 마찬가지입니다: 부품 분석 (3 페이지), 사용 설명서 (13 페이지), 사용 설명서 (10 페이지), 기술 정보 (13 페이지)
페이지 인쇄
For cleaner, safer cuts, set cut depth so that no more
than one blade tooth projects below workpiece. Using
proper cut depth helps to reduce potential for dangerous
KICKBACKS which can cause personal injury.
Sighting
1
007525
When cutting, align the A position on the front of the
base with your cutting line on the workpiece.
Switch action
1
007526
CAUTION:
Before inserting the battery cartridge into the tool,
•
always check to see that the switch trigger
actuates properly and returns to the "OFF" position
when released.
Do not pull the switch trigger hard without pressing
•
the lock-off lever. This can cause switch breakage.
To prevent the switch trigger from being accidentally
pulled, a lock-off lever is provided. To start the tool,
press the lock-off lever and pull the switch trigger.
Release the switch trigger to stop.
WARNING:
For your safety, this tool is equipped with lock-off
•
lever which prevents the tool from unintended
starting. NEVER use the tool if it runs when you
simply pull the switch trigger without pressing the
lock-off lever. Return tool a MAKITA service center
for proper repairs BEFORE further usage.
NEVER tape down or defeat purpose and function
•
of lock-off lever.
1. A position
2
2. Cutting line
3. Base
3
1. Switch trigger
2
2. Lock-off lever
Lighting the lamp
007527
CAUTION:
Do not look in the light or see the source of light
•
directly.
Only to turn on the light, pull the switch trigger without
pressing the lock-off lever. To turn on the light and run
the tool, press the lock-off lever and pull the switch
trigger with the lock-off lever being pressed.
NOTE:
Use a cotton stick to wipe the dirt off the lens of
•
lamp. Be careful not to scratch the lens of lamp, or
it may lower the illumination.
Do not use gasoline, thinner or the like to clean the
•
lens of lamp. Using such substances will damage
the lens.
ASSEMBLY
CAUTION:
Always be sure that the tool is switched off and the
•
battery cartridge is removed before carrying out
any work on the tool.
Removing or installing blade
2
007528
CAUTION:
Be sure the blade is installed with teeth pointing up
•
at the front of the tool.
Use only the Makita wrench to install or remove the
•
blade.
7
1. Lamp
1
1. Shaft lock
2. Hex wrench
1