Avanti AR4456SS 사용 설명서 - 페이지 10
{카테고리_이름} Avanti AR4456SS에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Avanti AR4456SS 20 페이지. Compact refrigerator
페이지 인쇄
Setting the Temperature Control
• Your unit has only one control for regulating the temperature in the compartment. The temperature
control is located on the upper right hand side of the compartment.
• The first time you turn the unit on, set the temperature control to "5".
• The range of the temperature control is from position "0" to "5". After 24 to 48 hours, adjust the
temperature control to the setting that best suites your needs. The setting of "3" should be
appropriate for home or office use.
• To turn the appliance off, turn the temperature control to "0".
NOTE:
Turning the temperature control to "0" position stops the cooling cycle but does not shut off the
power to the unit.
If the unit is unplugged, has lost power, or is turned off, you must wait 3 to 5 minutes before
restarting the unit. If you attempt to restart before this time delay, the unit will not start.
The Chiller Compartment ( RM4406W Series ONLY)
•
This compartment is designed for production of ice cubes and short-term storage (3-4 days at
most) of some commercially frozen foods.
•
The temperature in this compartment does not get cold enough to freeze food safely for long
periods of time and works best when the food is already frozen.
•
Be design, this chiller compartment is not a true freezer, and may not keep ice cream frozen, or
freeze items.
•
A colder setting may be used for these items, but other items in the refrigerator may also be
affected.
•
The chiller door is susceptible to breaking due to excessive ice build up. This part is not covered
under your warranty. Be sure to defrost when the ice reaches 1/4 inch thick.
Defrosting Your Unit (Models: RM4406W Series ONLY)
•
Defrost the unit when the frost accumulated on the evaporator is about 5mm (1/5 inch) thick. Set
the thermostat dial to "0" position.
•
Remove frozen or perishable foods from the chiller compartment and place it in a cooler to
protect the food.
•
Press the white defrost button on the temperature control.
•
During the defrost cycle, the ice melts into the water drip tray.
•
To remove the water, either remove the water drip tray and/or place a collection container under
the tray. Use a sponge or towel to pick up the melting ice off the unit floor.
•
Dry the water collection tray and place back under the chiller compartment. Defrosting usually
takes a few hours. After defrosting, return the thermostat dial to the desired position. To defrost
quickly remove all foods from the unit and leave the door open. Never use a knife or other metal
instrument to scrape ice/frost from the evaporator.
Using Your Ice Cube Tray (Models: RM4406W Series ONLY)
•
Recommended thermostat setting for ice making is the
maximum setting, 5.
•
Fill the ice cube tray two-thirds full with cold water or with
any liquid suitable for freezing and place the tray on the
floor of the freezer to freeze properly.
•
Be sure the bottom of the tray is dry, otherwise it may stick
to the floor of the freezer.
•
The best method of releasing ice cubes from the tray is to
hold the tray under cold tap water for a second.
OPERATING YOUR UNIT
CARE AND MAINTENANCE
10