Makita BFH090F 기술 정보 - 페이지 14
{카테고리_이름} Makita BFH090F에 대한 기술 정보을 온라인으로 검색하거나 PDF를 다운로드하세요. Makita BFH090F 18 페이지. Makstar 12v cordless screwdrivers
페이지 인쇄
W
iring diagram
(2) Wiring near the LED circuit and clutch switch unit
Put Controller section in place on Housing R, and install LED circuit on Housing R. And then as illustrated in
Fig. B, pull the following parts out of Housing R: Lead wires and Connectors from LED circuit, Clutch switch unit.
Fig. B
These parts must be
placed out of Housing R.
1
2
3
4
5
(3) Wiring near the trigger switch section
Place Switch section in place on Housing R. See Fig. C for the wiring.
The lead wires to Switch unit of Trigger section must be placed between Pin 1 and Pin 2.
Also do not fail to place the lead wire to Switch unit for rotational direction change between Pin 2 and Pin 3.
Fig. C
Switch unit of trigger section
Lead wire to switch unit of
trigger section (white)
Lead wire to switch unit of
trigger section (yellow)
Lead wire to Switch unit for
rotational direction change
(yellow)
Lead wire to Switch unit for
rotational direction change
(blue)
Controller section of
6
Motor control unit
7
LED circuit
Lead wire from
Motor control unit (yellow)
1. Clutch switch unit
2. Lead wire to Motor control unit (yellow)
3. Lead wire to Motor control unit (purple)
4. Lead wire from LED circuit (gray)
5. Lead wire from LED circuit (blue)
6. Lead wire to Motor control unit (gray)
7. Lead wire to Motor control unit (blue)
Housing R
Lead wire to Switch unit for
rotational direction change
(yellow)
Pin2
Lead wire from
Motor control unit (blue)
P 14 / 17
Lead wire to Switch unit for
rotational direction change
(blue)
Pin1
Pin3