Makita BFL400F 사용 설명서 - 페이지 8
{카테고리_이름} Makita BFL400F에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Makita BFL400F 13 페이지. Cordless angle screwdriver
Makita BFL400F에 대해서도 마찬가지입니다: 사용 설명서 (17 페이지), 기술 정보 (13 페이지), 사용 설명서 (10 페이지)
페이지 인쇄
Adjusting the fastening torque
1
005750
1
2
3
4
005740
When you wish to drive machine screws, wood screws,
hex bolts, etc. with the predetermined torque, adjusting
the fastening torque as follows.
1.
First remove the battery cartridge from the tool.
2.
Loosen and remove the screw that secures ring.
3.
Rotate the ring in the front of the tool by hand so
that a hole can be seen below the ring.
4.
Place the battery cartridge in place and pull the
switch trigger. Release it so that the adjusting ring
rotates and becomes visible in the hole. And then
remove the battery cartridge.
005741
5.
Use an optional adjusting grip to adjust the
fastening torque. Insert the pin of the adjusting
grip into the hole in the front of the tool. And then,
turn the adjusting grip clockwise to set a greater
fastening torque, and counterclockwise to set a
smaller fastening torque.
6.
Align the edge of the adjusting ring with your
desired number on the fastening torque scale.
7.
Insert the battery cartridge and be sure that a
fastening torque has been set up by using a
fastening torque tester.
1. Screw
1. Angle head
7
2. Ring
3. Scale
4. Compression
6
spring
5. Yellow line
6. Hole for
adjusting grip
5
7. Adjusting grip
8.
Rotate the ring in front of the tool and then tighten
the screw to secure the ring.
NOTE:
Numbers on the fastening torque scale is a
•
guideline to set up your desired fastening torque.
ASSEMBLY
CAUTION:
Always be sure that the tool is switched off and the
•
battery cartridge is removed before carrying out
any work on the tool.
Selecting correct socket
There are different types of sockets for some models
depending on applications. Choose and install a correct
socket for your application.
Installing or removing socket
1
2
3
005742
To install the socket, push it onto the square drive of the
tool with one hand by depressing a pin on the square
drive with another hand until it locks into place. To
remove the socket, simply pull it off depressing the pin
on the square drive.
OPERATION
Hold the tool firmly and place the socket over the bolt or
nut. Then switch the tool on. When the clutch cuts in, the
motor will stop automatically. Then release the switch
trigger.
NOTE:
Hold the tool with its square drive pointed straight
•
at the bolt or nut, or the bolt or nut will be
damaged.
8
1. Socket
2. Hole
3. Pin