GARCARE GPCS06 사용 설명서 - 페이지 13

{카테고리_이름} GARCARE GPCS06에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. GARCARE GPCS06 15 페이지. Corded pole saw

4）Adjustment of rear handle

See Fig. F

Press the rotary push button and adjust the rear head until it snaps into the desired

position.

5）Assembly of chain bar and chain

See Fig. G

Remove the bar retaining nut. Remove the chain sheath by pulling straight out, some

force may be required. (See Fig. 1)

Slip the chain around the sprocket behind the clutch. Make sure the links fit between the

sprocket teeth. Place a suitable socket spanner over the bar bolts. Slide guide bar

behind clutch drum until the guide bar stops. (See Fig. 2, 3, 4)

Reset the chain sheath and tighten retaining nut. (See Fig. 5)

6）Check of the chain oil level

See Fig. H

Always check the chain oil tank before use tool each time. We recommend using our

replacement chain and bar. Always use good quality sprocket oil, which contains

additives to reduce friction and wear and to assist in the prevention of pitch formation on

the bar and chain. If the oil level height below the scale line "MIN" which mark on the

housing beside the oil gauge, it must refill the chain oil tank cap and inject the chain saw

special lubricants. (See Fig. 2, 3, 4, 5)

Operation

1) To start

See Fig. 10

To start the tool: Depress the safety lock-off button, and then press the ON/ OFF switch.

Release the safety button once the motor has started.

2) To stop

See Fig. 11

To stop the tool: Release the ON/OFF switch.

Cleaning and maintenance

 Check your machine regularly before starting the work.

 Always keep the ventilation slots in motor housing clean.

 Never clean or spray a machine with water. Clean the motor housing only with a

moist cloth and never apply detergents or solvents! These could ruin the plastic parts

of the machine.

 Finally dry the motor housing carefully.

 Store the machine with the supplied protection cover.

 Only use original accessories and spare parts.