ALIBI ALI-CD1080E 빠른 설치 매뉴얼 - 페이지 2

{카테고리_이름} ALIBI ALI-CD1080E에 대한 빠른 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. ALIBI ALI-CD1080E 4 페이지.

페이지 인쇄

Separate the enclosure, the camera module and the mounting base.

Using the mounting template or the mounting base, mark the holes for the camera mounting

screws.

Drill holes for the screws that anchor the base to the mounting surface. The mounting hardware

provided is appropriate for most surfaces. However, depending on the surface material and strength,

more appropriate fasteners may be required.

Drill a 3/4" hole through the mounting surface for the drop cable, if necessary.

If using wall inserts for the mounting screws, install the wall inserts at this time.

Attach the mounting base the surface using the appropriate fasteners. If the camera drop cable will

route through a cable channel, lay the cable in the channel before tightening the mounting screws.

If the drop cable will route through a hole in the mounting surface, route the cable through the hole,

and then reassemble the camera on the mounting base. Tighten the bezel only enough to hold the

assembly together, but do not tighten the bezel.

Connect the camera drop cable to video and power extension cables.

10.

Connect the other end of the video extension cable to a video monitoring device, such as a HD-TVI

capable DVR.

Drop cable connectors are not waterproof.

NOTE

11.

Connect the other end of the power extension cable to a 12 Vdc power source. Observe the polarity

of the cable shown in the photo on page 1 of this guide.

Step 2.

Camera adjustments

Apply power to the camera.

Verify that video from the camera can be seen on the HD-TVI DVR (HVR) monitor.

While observing video from the camera, adjust camera direction, tilt and horizontal alignment to

point the camera at your surveillance target. Loosen the bezel if needed to so the camera module

can be adjusted easily.

While holding the camera module and enclosure in place, tighten the bezel to lock the camera in

position.

www.observint.com

Step 3.

Open the OSD menu

The On Screen Display (OSD) provides configuration options for refining the performance of the camera.

It also can be used to block sensitive portions in the field of view (Privacy). You can open the OSD menu

system from either the HVR Live View display or through remote login to the HVR.

Opening the OSD Menu through the HVR

To open the OSD menu on the HVR monitor:

Open the HVR Live View screen, and then click inside the screen where the PTZ camera video image

is displayed. See below.

Click the PTZ Control icon in the Quick Setting Toolbar. The PTZ camera Live View window will

expand to full screen and the pop-up window shown below will open.

Menu icon

In the PTZ Control panel pop-up window, click the Menu icon on the Configuration line.

Drag the PTZ Control window to a position where it doesn't cover the OSD menu (such as the lower-

right corner.

The PTZ Control window direction buttons and the Iris + and Iris - keys are used to navigate the

NOTE

OSD menu and set configuration options in the camera. See "OSD menu navigation" on page 3.

Opening the OSD Menu through remote login to the HVR

To open the OSD menu during a remote login to the HVR:

After logging into the HVR, open the PTZ camera in a single Live View window.