James May Engineering Ultra Tonic 설치 지침 매뉴얼 - 페이지 5

{카테고리_이름} James May Engineering Ultra Tonic에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. James May Engineering Ultra Tonic 8 페이지. Pickup version 3 for steel string guitars

페이지 인쇄

3. Install the Volume Control

Peel off the protective tape and firmly press the volume control board to the underside of the top so

that the thumbwheel is accessible through the sound hole. Position it as high up on the sound hole as

the bracing pattern will allow. This will give the easiest access for adjustment during performance. If you

need to reposition, it will come off cleanly without damage to the wood.

Cable Compensation Feature

For use with normal 12-15Ft guitar cables, leave the cable compensation switch set to on. This will

prevent loss of highs when dialing down the volume, caused by the capacitance of the guitar cable.

(Using a longer cable or one with more capacitance will result in only a slight change in high frequencies

when adjusting the volume.)

If using a very short cable, such as with a wireless system, turn the cable compensation to OFF. The

switch can be accessed with the finger even after mounting.

Option – Remove the Volume Control

If the volume control is not required, unsolder the white and red wires from pads P4 and P5, and the

shield connection from rear ground plane. To complete the circuit, solder a short piece of wire between

pads P4 and P5 as shown here.