Makita BHS630 사용 설명서 - 페이지 9

{카테고리_이름} Makita BHS630에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Makita BHS630 13 페이지.
Makita BHS630에 대해서도 마찬가지입니다: 기술 정보 (16 페이지)

페이지 인쇄

NEVER tape down or defeat purpose and function

•

of lock-off lever.

Lighting the lamp

CAUTION:

Do not look in the light or see the source of light

•

directly.

012106

Only to turn on the light, pull the switch trigger without

pressing the lock-off lever. To turn on the light and run

the tool, press the lock-off lever and pull the switch

trigger with the lock-off lever being pressed.

NOTE:

Use a dry cloth to wipe the dirt off the lens of lamp.

•

Be careful not to scratch the lens of lamp, or it may

lower the illumination.

Do not use gasoline, thinner or the like to clean the

•

lens of lamp. Using such substances will damage

the lens.

ASSEMBLY

CAUTION:

Always be sure that the tool is switched off and the

•

battery cartridge is removed before carrying out

any work on the tool.

Removing or installing saw blade

CAUTION:

Be sure the blade is installed with teeth pointing up

•

at the front of the tool.

Use only the Makita wrench to install or remove the

•

blade.

012094

1. Light

1. Shaft lock

2. Hex wrench

3. Loosen

To remove the blade, press the shaft lock so that the

blade cannot revolve and use the wrench to loosen the

hex bolt counterclockwise. Then remove the hex bolt,

outer flange and blade.

To install the blade, follow the removal procedure in

reverse. BE SURE TO TIGHTEN THE HEX BOLT

CLOCKWISE SECURELY.

012096

When changing blade, make sure to also clean upper

and lower blade guards of accumulated sawdust. Such

efforts do not, however, replace the need to check lower

guard operation before each use.

Hex wrench storage

012097

When not in use, store the hex wrench as shown in the

figure to keep it from being lost.

Connecting a vacuum cleaner (for European

countries only)

012113

1. Hex bolt

2. Outer flange

3. Saw blade

4. Inner flange

1. Hex wrench

1. Dust nozzle

2. Thumb screw