Makita BHS630 기술 정보 - 페이지 13

{카테고리_이름} Makita BHS630에 대한 기술 정보을 온라인으로 검색하거나 PDF를 다운로드하세요. Makita BHS630 16 페이지.
Makita BHS630에 대해서도 마찬가지입니다: 사용 설명서 (13 페이지)

페이지 인쇄

epair

[4] ADJUSTMENT

Following two kinds of adjustment screws are used in this product.

1. M6x8 Hex socket head set screw for adjusting Accuracy of 90 degrees .

2. M5x8 hex socket head set screw for adjusting Accuracy of Parallel of Base to saw blade

See the following drawing in Fig. 17.

Fig. 17

2. M5x8 Hex socket head set screw

for adjusting accuracy of parallel

of Base to saw blade

[4]-1. Adjusting Accuracy of 90 degree cut

Mounting Saw blade to the machine, set the machine to the lowest possible position to obtain the max. cut depth.

But, do not attach Battery to the machine.

Adjust accuracy of 90 degree cut as drawn in Fig. 18.

Fig. 18

Apply triangular rule as per the illustration

and adjust the accuracy of right angle by turning

M6x8 Hex socket head set bolt with hex wrench,

until the two sides of the adjusting jig fit to Base

and saw blade completely.

[4]-2. Adjusting Accuracy of Parallel of Base to Saw blade

Mounting Saw blade to the machine, set the machine to the lowest possible position to obtain the max. cut depth.

But, do not attach Battery to the machine.

Adjust accuracy of parallel of Base to saw blade as drawn in Fig. 19.

Fig. 18

1. Loosen M5x8 Hex socket head set screw

with Hex wrench a little bit.

2. Apply square to the machine as per the

illustration.

3. Adjust by moving the rear side of base,

until the Square fits both to the saw blade

and the front edge of base.

Base

1. M6x8 Hex socket head set screw

for adjusting accuracy of 90 degree

of Base to saw blade

Triangular rule or 1R208

M5x8 Hex socket

head set screw

Rear side

of Base

Hex wrench

M6x8 Hex socket

head set bolt

Square

Saw blade

Front edge of

Base

P 13/ 16