FRIONOR DVS2500 사용 및 유지 관리 지침 - 페이지 5

{카테고리_이름} FRIONOR DVS2500에 대한 사용 및 유지 관리 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. FRIONOR DVS2500 17 페이지. Vitroceramic cooktop

페이지 인쇄

its service agent, or similarly qualified persons in

order to avoid a hazard.

3. ELECTRICAL SHOCK HAZARD DURING

USE & MAINTENANCE

Do not cook on a broken or cracked cooktop. If the

cooktop surface is broken or cracked, switch the

appliance off immediately at the mains power sup-

ply (wall switch) and contact a qualified technician.

WARNING: Be very careful as panel edges might

be sharp. Failure to use caution could result in

injury or cuts.

4. DISPOSAL OF OLD ELECTRICAL APPLIANCES

The European Directive 2002/96/EC on

Waste Electrical and Electronic Equip-

ment (WEEE), requires that old house-

hold electrical appliances must not be

disposed of in the normal unsorted mu-

nicipal waste stream. Old appliances

must be collected separately in order to

optimize the recovery and recycling of

the materials they contain and reduce the

impact on human health and the environ-

ment. The crossed-out dustbin symbol

on the product reminds you of your obli-

gation regarding separated waste collec-

tion. Consumers should contact their lo-

cal public service or their local dealer for

more information on the correct disposal

of exhausted household appliances.

INSTALLATION

1. INSTRUCTIONS

1. The domestic appliance was built in order to

be encased on a work surface, the way it is

illustrated in the graph (image 1). Predispose

sealing material (image 2) along the whole

perimeter. Lock the domestic appliance into

place with 4 clips, screwing at the sides (im-

age 4). If the lower part of the appliance after

installation, is accessable via the lower part of

the furniture, it is necessary to mount a sep-

arating panel keeping in mind the distances

indicated (image 3).

2. Do not install refrigerators, dishwashers,

non-ventilated ovens or washing machines un-

der the appliance.

3. The built-in kitchen units must withstand tem-

peratures of up to 90°C.

4. A gap of at least 90 mm must be allowed between

the hob and the side wall, where applicable.

5. It is not recommended that the hob be placed

between two side walls but, if this is the case,

a gap of at least 200 mm should be left on one

side and a gap of 90mm on the other.

2. ELECTRICAL CONNECTIONS (image 5)

1. Before making the electrical connections,

check that:

• The system ratings meet the ratings indi-

cated on the identification plate fixed on the

lower part of the worktop.

• The system is fitted with efficient ground

wires in accordance with the laws and current

standards. Grounding is mandatory by law.

• The connection to the mains should be done

with the appropriate cable and from a spe-

cialized technician.

• If necessary, fit the cooper bridges supplied.

2. Power cord: Type H05 VV-F or higher, determi-

nate the required wire cross-section depend-

ing on the current rating.

3. A cross-section of < 1,5mm² is not permissible.

4. If wishing to make a direct connection to the

mains, an omnipolar switch must be installed

with a minimum 3mm opening between the

contacts and appropriate for the load indicat-

ed on the plate and in accordance with current

standards (the yellow/green ground conductor

must not be disconnected by a switch). When

the appliance has been installed, the omnipo-

lar switch must be easily reachable.