Makita BJV180 사용 설명서 - 페이지 8
{카테고리_이름} Makita BJV180에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Makita BJV180 13 페이지. Cordless jig saw
Makita BJV180에 대해서도 마찬가지입니다: 부품 분석 (3 페이지), 사양 시트 (2 페이지), 사용 설명서 (13 페이지), 사용 설명서 (13 페이지), 기술 정보 (13 페이지), 사용 설명서 (18 페이지)
페이지 인쇄
Dust extraction
The dust nozzle (optional accessory) is recommended to
perform clean cutting operations.
1
001921
To attach the dust nozzle on the tool, insert the hook of
dust nozzle into the hole in the base.
The dust nozzle can be installed on either left or right
side of the base.
001922
Then connect a Makita vacuum cleaner to the dust
nozzle.
1
007495
OPERATION
CAUTION:
Always hold the base flush with the workpiece.
•
Failure to do so may cause blade breakage,
resulting in a serious injury.
1. Dust nozzle
2. Base
2
1. Dust nozzle
2. Hose for
vacuum cleaner
2
1
007487
Turn the tool on without the blade making any contact
and wait until the blade attains full speed. Then rest the
base flat on the workpiece and gently move the tool
forward along the previously marked cutting line.
NOTE:
If the tool is operated continuously until the battery
•
cartridge has discharged, allow the tool to rest for
15 minutes before proceeding with a fresh battery.
When cutting curves, advance the tool very slowly.
Bevel cutting
007488
CAUTION:
Always be sure that the tool is switched off and the
•
battery cartridge is removed before tilting the base.
With the base tilted, you can make bevel cuts at any
angle between 0° and 45° (left or right).
Loosen the bolt on the back of the base with the hex
wrench. Move the base so that the bolt is positioned in
the center of the bevel slot in the base.
2
1
007489
8
1. Cutting line
2. Base
2
1. Base
3
2. Bolt
3. Hex wrench