Makita BO4563 사용 설명서 - 페이지 5

{카테고리_이름} Makita BO4563에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Makita BO4563 8 페이지. Finishing sander

페이지 인쇄

004514

To attach the sandpaper:

Set the tool upside down so that the pad is on top.

Position the sandpaper to fit the shape of the base.

Be sure to align the holes on the sandpaper with

the holes on the pad (the dust will be sucked into

these holes; it is therefore important to leave them

open).

Press the paper firmly over the pad.

To remove the sandpaper:

Set the tool upside down so that the sandpaper is

on top.

Grasping one corner of the sandpaper, peel it from

the pad.

NOTE:

If the sandpaper is in good condition, save it for

•

further use.

When sanding in narrow, hard-to-reach areas (e.g.,

shutters, blinds, louvers), attach the cone-shaped

abrasive papers to the end of the pad (bottom and top).

To sand the end of thin materials, fold the abrasive paper

and attach to the side of the pad as shown in the figures.

Dust bag

The use of the dust bag makes sanding operations clean

and dust collection easy. To attach the dust bag, fit the

bag's entry port onto the dust spout on the tool. Make

sure that the hole in the bag's entry port is just over the

pimple-like protrusion on the dust spout.

004441

For the best results, empty the dust bag when it becomes

approximately half full, tapping it lightly to remove as

much dust as possible.

1. Velcro

sandpaper

2. Base

1. Dust bag

2. Hole

3. Entry port

4. Dust spout

5. Protrusion

Installing paper dust bag (optional accessory)

003742

Place the paper dust bag on the paper dust bag holder

with its front side upward. Insert the front fixing cardboard

of the paper dust bag into the groove of the paper dust

bag holder.

Then press the upper part of the front fixing cardboard in

arrow direction to hook it onto the claws.

003743

Insert the notch of the paper dust bag into the guide of

the paper dust bag holder. Then install the paper dust

bag holder set on the tool.

003744

003745

1. Groove

2. Front fixing

cardboard

3. Front side of

paper dust bag

1. Claws

2. Upper part

1. Notch

2. Guide