Gardco PG-1 사용자 설명서 - 페이지 16

{카테고리_이름} Gardco PG-1에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Gardco PG-1 17 페이지. The pocket goniometer

Carrier strip for soft or warping test materials

The box with adhesive tapes contains a black carrier strip made of anti-static material.. The

adhesive strips have different adhesives on the two sides.

Apply the adhesive strip on the carrier strip as follows:

Remove the yellow backing from the adhesive strip.

This side has a "hard sticky" adhesive.

Attach the sticky side to the carrier strip and press firmly on top of the adhesive strip

Make sure the adhesive tape does not extend outside the edges of the carrier strip.

Remove the release paper on top of the adhesive strip.

The top side is now the "soft adhesive" which can be used for multiple specimen strips.

Cut a 14-15 mm wide specimen strip and apply it on top of the adhesive strip.

Press specimen strip against a clean, flat surface, which does not contaminate the

specimen. Regarding sample preparation, see Section 5.

Make sure the specimen does not extend outside the edges of the carrier strip.

Insert the carrier strip into the specimen stage (Section 2.2).

After test is completed, remove the specimen and apply a new specimen using the

existing adhesive strip.

Thick release paper

Adhesive tape

Carrier strip

Appendix A

Double-sided adhesive

Thin release paper