Makita BTM40 사용 설명서 - 페이지 9
{카테고리_이름} Makita BTM40에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Makita BTM40 12 페이지. Cordless multi tool
Makita BTM40에 대해서도 마찬가지입니다: 기술 정보 (10 페이지)
페이지 인쇄2
1
3
012767
Put an application tool (optional accessory) on the tool
flange so that the protrusions of the tool flange fit in the
holes in the application tool and secure the application
tool by tightening the bolt firmly with the hex wrench.
When using sanding application tool, mount the
application tool on the sanding pad so that it matches the
sanding pad direction.
The sanding pad has a hook and loop type fitting system
which allows easy and rapid fitting of a sanding paper.
As sanding papers have holes for dust extraction, mount
a sanding paper so that the holes in a sanding paper
match those in the sanding pad.
To remove a sanding paper, raise its end and peel it off.
Loosen and remove the application tool installation bolt
using a hex wrench and then take off the application tool.
1
2
3
4
012847
When using application tools with a different type of
installation section, use a correct adapter (optional
accessory).
Hex wrench storage
012766
When not in use, store the hex wrench as shown in the
figure to keep it from being lost.
1. Application tool
installation bolt
2. Hex wrench
3. Tighten
1. Application tool
installation bolt
2. Holes in the
application tool
3. Adapter (required
for some
application tools)
4. Protrusions of
the tool flange
1. Hex wrench
1
OPERATION
WARNING:
Before starting the tool and during operation, keep
•
your hand and face away from the application tool.
CAUTION:
Do not apply excessive load to the tool which may
•
cause a motor lock and stop the tool.
Cutting, sawing and scraping
CAUTION:
Do not move on the tool forcibly in the direction (eg.
•
towards either side) of tool application with no
cutting edge. It may damage the tool.
012801
Put the application tool on the workpiece.
And then move the tool forward so that the application
tool movement does not slow down.
NOTE:
Forcing or excessive pressure on the tool may
•
reduce efficiency.
Before cutting operation, it is recommended to
•
preset the orbital stroke rate 4 - 6.
Sanding
CAUTION:
Do not reuse a sanding paper used for sanding
•
metal to sand wood.
Do not use a worn sanding paper or sanding paper
•
without grit.
012769
Apply a sanding paper on the workpiece.
9