Garde 181KS2STG 사용자 설명서 - 페이지 3
{카테고리_이름} Garde 181KS2STG에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Garde 181KS2STG 3 페이지. 2 stage electric knife sharpener
페이지 인쇄Operation
1.
Place the appliance on a table or sturdy surface.
2.
Start the appliance by turning the ON/OFF switch to the "On" position.
NOTE: Be sure to operate the appliance from the front such that you are facing the side labeled with the stages.
3.
Place the end of the knife in either one of the blade modules of the first stage, labeled "Coarse". Slowly pull the
blade down and through the Stage 1 blade guides. Then place your blade on the opposite side of the Stage 1
blade module and slowly pull the blade down and through.
Note: Blade strokes should take between 3-5 seconds for a standard 5" blade.
Note: Avoid excessive downward pressure on the sharpening discs. Only mild pressure is needed for knife to
contact sharpening discs.
4.
Alternate sides in Stage 1 until you have completed 2-3 pairs of alternating pulls, or until you can feel a burr present.
5.
Place the end of the knife in either one of the blade modules in the second stage, labeled "Polish". Slowly pull
the blade down and through the Stage 2 blade guides. Then place your blade on the opposite side of the Stage 2
blade module and slowly pull down and through.
6.
Alternate sides in Stage 2 until you have completed 3-4 pairs of alternating pulls, or until you can no longer feel
the burr present.
7.
Test the sharpness of the knife by slicing a ripe tomato or piece of paper.
8.
If the knife is not sharpened to your satisfaction, repeat steps 5-6.
Resharpening
1.
Straight Knives can be resharpened 3-5 times using Stage 2 before knives will need to be sharpened in stage 1.
2.
For resharpening beginning in stage 2, refer to steps 1-2 and 5-6 under "Operation".
3.
For resharpening beginning in stage 1, refer to steps 1-6 under "Operation".
Cleaning and Maintenance
Refrain from using water or harsh detergents when cleaning your knife sharpener. To remove any debris from the exte-
rior, a damp cloth with mild detergent such as dish soap is recommended. As needed, the swarf collection compartment
can be emptied to remove any metal dust that has accumulated.