Makita BTS130 사용 설명서 - 페이지 7

{카테고리_이름} Makita BTS130에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Makita BTS130 12 페이지. Cordless oil-impulse driver

페이지 인쇄

To install the bit, pull the sleeve in the direction of

the arrow and insert the bit-piece and bit into the

sleeve as far as it will go. The bit-piece should be

inserted into the sleeve with its pointed end facing

in. Then release the sleeve to secure the bit.

011407

To remove the bit, pull the sleeve in the direction of the

arrow and pull the bit out firmly.

NOTE:

If the bit is not inserted deep enough into the sleeve,

•

the sleeve will not return to its original position and

the bit will not be secured. In this case, try

re-inserting the bit according to the instructions

above.

Hook

006592

The hook is convenient for temporarily hanging the tool.

This can be installed on either side of the tool.

To install the hook, insert it into a groove in the tool

housing on either side and then secure it with a screw. To

remove, loosen the screw and then take it out.

1. Bit

2. Bit-piece

3. Sleeve

1. Screw

2. Hook

3. Groove

OPERATION

006843

CAUTION:

Never obstruct the air vents on the side of the tool

•

for cooling down oil unit and motor during operation.

Failure to do so may cause the tool excessive

hotness and damage.

The proper fastening torque may differ depending upon

the kind or size of the screw/bolt, the material of the

workpiece to be fastened, etc. The relation between

fastening torque and fastening time is shown in the

figures.

Standard bolt

N m

(ft lbs)

(306)

(204)

(102)

0.5

Fastening time (S)

006841

1. Air vents

2. Cooling down oil

unit

M10

1.0