Makita BTW070 사용 설명서 - 페이지 5
{카테고리_이름} Makita BTW070에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Makita BTW070 12 페이지.
Makita BTW070에 대해서도 마찬가지입니다: 기술 정보 (6 페이지), 사용 설명서 (16 페이지)
페이지 인쇄
FUNCTIONAL
DESCRIPTION
2
1. Battery cartridge
2. Button
Indicating lamp
F Capacity
(C)
E
orange
Indicating lamp
E
F
orange
1
1. Switch trigger
CAUTION:
•
Always be sure that the tool is switched off and the battery cartridge is
removed before adjusting or checking function on the tool.
Installing or removing battery cartridge
001251
•
Always switch off the tool before installation or removal of the battery
cartridge.
•
To remove the battery cartridge, withdraw it from the tool while pushing
the buttons on both sides of the battery cartridge.
•
To insert the battery cartridge, align the tongue on the battery cartridge
with the groove in the housing and slip it into place. Always insert it all the
1
way until it locks in place with a little click. If not, it may accidentally fall
out of the tool, causing injury to you or someone around you.
•
Do not use force when inserting the battery cartridge. If the cartridge
does not slide in easily, it is not being inserted correctly.
Checking the remaining battery capacity
001254
When charging
When the charging begins, the first (far left) indicating lamp begins to flicker.
Then, as charging proceeds, the other lamps light, one after the other, to indi-
cate the battery capacity.
80% - 100%
When using
60% - 80%
40% - 60%
When the tool is switched on, the lamps will light to indicate the remaining bat-
10% - 40%
tery capacity. When the tool is switched off, the light goes out after approx. 5
seconds. If the battery cartridge has not been used for a long time, or is
0% - 10%
needed refresh charging, the orange lamp begins to flicker. Use Makita
refreshing adapter to refresh the battery cartridge.
Capacity
CAUTION:
80% - 100%
•
A battery cartridge extracted from the charger that has been unplugged
60% - 80%
with the battery cartridge inserted does not work even if it is inserted in
40% - 60%
the tool. At this time, recharge it for about five seconds before use.
10% - 40%
0% - 10%
Switch action
001255
CAUTION:
•
Before inserting the battery cartridge into the tool, always check to see
that the switch trigger actuates properly and returns to the "OFF" position
when released.
To start the tool, simply pull the switch trigger. Tool speed is increased by
increasing pressure on the switch trigger. Release the switch trigger to stop.
5