Garde 181COM1BSTMA 빠른 시작 매뉴얼 - 페이지 2

{카테고리_이름} Garde 181COM1BSTMA에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Garde 181COM1BSTMA 2 페이지. Heavy-duty #10 can opener

페이지 인쇄

The can opener's surface and knife should be cleaned regularly using a food safe sanitizer.

Recommendation: Noble Chemical's QuikSan Sanitizer and Disinfectant (147QUIKSAN)

Use a toothbrush-style brush to ensure you are able to reach the crevices around the knife.

Recommendation: Scrubble Products 7¼" Utility Brush with Stainless Steel Bristles (27140675)

After cleaning, apply a food safe oil to the gear to keep it turning smoothly.

Recommendation: Petrol-Gel Food Grade Sanitary Lubricant - 4 oz. Tube (401PETROGEL)

Replacing The Knife

(181CO1KNIFMA)

1. Using either a Phillips or flat

head screw driver, remove the 2

screws that connect the knife to

the opener.

2. Remove and discard the old

knife while keeping the knife

support plate.

3. Position the new knife in line

with the holes and place the

support plate on top of the knife.

4. Use the screwdriver to tighten

the screws.

It is recommended the knife and gear are replaced at the same time for optimal performance

Replacement parts can be purchased from the same location

Plated Steel Base

181BASE1PSMA

Stainless Steel Base

181BASE1SSMA

Knife

181CO1KNIFMA

This can opener is guaranteed to be free of defects in materials and workmanship for the

period of 1 Year. The warranty does not cover the knife and gear. The warranty does not

cover failure due to neglect, misuse or improper handling. The warranty does not apply to

any use of or sale of the product outside of the United States.

Cleaning/Maintenance

1. Insert the can opener into the base. The base will be needed

for leverage while removing the gear.

2. Use a flat head screw driver to hold the gear in place by

jamming the head of the screw driver into the teeth of the

old gear. You will need to apply enough pressure to hold the

gear in place.

3. With the screw driver in place, begin turning the handle

counter clockwise. You should feel the tension in the spring

ease up and the gear will come loose after a few turns.

4. Remove the old gear and keep the washer. Insert the new

gear with the washer on top. Turn the handle clockwise until

the handle connects to the shaft below the gear. The spring

should be tense now and the can opener ready to use.

Replacement Parts

the can opener was purchased.

Knife & Gear Kit

181COM1KITMA

Knife Support

181COM1SUPMA

Screw Set

181CO1SCRWMA

Warranty

Replacing The Gear

(181CO1GEARMA)

181CO1GEARMA

181CO1WASHMA

Gear

Washer