Makita BTW074 기술 정보 - 페이지 6

{카테고리_이름} Makita BTW074에 대한 기술 정보을 온라인으로 검색하거나 PDF를 다운로드하세요. Makita BTW074 15 페이지.
Makita BTW074에 대해서도 마찬가지입니다: 사용 설명서 (13 페이지)

페이지 인쇄

epair

[3] DISASSEMBLY/ASSEMBLY

[3] -2. Armature (cont.)

ASSEMBLING

(3) Assemble Motor section (Armature, Yoke unit ), Internal gear case and Brush holder to Housing set (L) as drawn

in Fig. 8.

Fig. 8

Housing Set (L)

The flat surface of Brush

holder complete has to be

mounted perpendicularly.

(4) Mount Pig tails and Spacers as drawn in Fig. 9.

Fig. 9

1. Spacer has to be set inside

the housing wall.

projection

Spacer

2. Aligning this groove with

the projection of Brush holder,

push Spacer toward Armature

until it stops.

(5) Assemble F/R change lever as drawn in

Fig. 10

1. Set F/R change lever to Switch with aligning

the prong portion with the projection.

Projection

of Switch

(6) Be sure to assemble ID plate and Cover complete or Switch plate complete to Housing set (L) in accordance with

[3] -1. Note for Assembly/Disassembly

90°

The edge of Yoke unit

has to be set inside of

the rib.

The marking on Yoke

unit should be facing

upward.

Fig. 10

Prong portion of

F/R change lever

d the drawings in Fig. 2. And then, assemble Housing set (R).

Rib

Pig tails

Note: Make sure that the loosening of

Pig tail is within 9 mm from

the edge of Brush holder.

9mm

2. Assemble Switch with F/R change lever

to Housing set (L).

P 6/ 15

Yoke unit

Mark