KitchenAid KERS205TBL - ARCHITECTII - Electric Range 설치 지침 매뉴얼 - 페이지 8
{카테고리_이름} KitchenAid KERS205TBL - ARCHITECTII - Electric Range에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. KitchenAid KERS205TBL - ARCHITECTII - Electric Range 20 페이지. 30" (76 cm) freestanding electric ranges
페이지 인쇄
4. Add strain relief.
Style 1: Power supply cord strain relief
■
Assemble a UL listed strain relief in the opening.
A
A. UL listed strain relief - large opening
B. Small opening
■
Feed the power supply cord through the strain relief on
the cord/conduit plate on bottom of range. Allow enough
slack to easily attach the wiring to the terminal block.
■
Tighten strain relief screw against the power supply cord.
Style 2: Direct wire strain relief
■
Use Phillips screwdriver to remove screws and rotate/
conduit plate 180º.
A. Large opening
B. Small opening
■
Position cord/conduit plate as shown in the following
illustration.
A. Small opening
B. Large opening
8
B
B
A
B
A
■
Replace cord/conduit plate and insert screws.
A. Small opening
B. Large opening
■
Assemble a UL listed conduit connector in the opening.
A
A. Removable retaining nut - small opening
B. Conduit connector
C. Large opening
■
Feed the flexible conduit through the strain relief, allowing
enough slack to easily attach wiring to the terminal block.
■
Tighten strain relief screw against the flexible conduit.
5. Replace back panel and screws on rear of range.
6. Complete installation following instructions for your type of
electrical connection:
4-wire (recommended)
3-wire (if 4-wire is not available)
B
A
C
B