Makita DBN600 사용 설명서 - 페이지 8

{카테고리_이름} Makita DBN600에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Makita DBN600 13 페이지. Cordless finish nailer
Makita DBN600에 대해서도 마찬가지입니다: 사용 설명서 (13 페이지)

페이지 인쇄
Makita DBN600 사용 설명서
► 1 . Lamp
NOTE: Use a dry cloth to wipe the dirt off the lens of
the lamp. Be careful not to scratch the lens of lamp, or
it may lower the illumination.
NOTE: The nailer may not fire nails even if the lamp
lights up because the remaining battery power is low.
In this case, charge the battery cartridge.
ASSEMBLY
CAUTION:
Always make sure that your
fingers are not placed on the switch trigger or
the contact element and the battery cartridge is
removed before carrying out any work on the
nailer.
Loading or unloading the nails
CAUTION:
Always make sure that the battery
cartridge is removed before loading the nails.
Unintentional firing may cause personal injuries and
property damage.
CAUTION:
Do not abruptly slide the pusher
lever on the magazine loaded with nails.
Accidentally dropping nails especially when working
in high places may cause personal injuries.
CAUTION:
Load the nails in the correct direc-
tion. Loading in wrong direction may cause prema-
ture wear and tear of the driver and damage of the
other parts.
CAUTION:
Do not use deformed connected
nails. Use nails specified in this manual. Using nails
other than those specified may cause the nail jam-
ming and breakage of the nailer.
1.
Remove the battery cartridge.
2.
Pull the pusher lever down ward until it locks with
a little click.
1
► 1 . Pusher lever
3.
Insert a connected nails into the slit on the bottom
of the magazine.
► 1 . Slit 2. Connected nail
4.
Press the pusher button.
The pusher lever is unlocked and it holds the nails in
the magazine.
► 1 . Pusher button
Be careful not to place your finger
CAUTION:
on the rail of the pusher lever when pressing
the pusher button. The pusher may hit your finger
strongly and cause injury.
NOTICE:
If the inserted connected nails remain
in the bottom of the magazine, pusher lever does
not return even if you press the pusher button.
Bring the connected nails into the magazine so that
the entire connected nails can be seen.
To remove nails, follow the installation procedures in reverse.
8 ENGLISH
1
1
2
1